Sper-scientific 850037 Large Display Conductivity Pen Manuel d'utilisateur télécharger pdf (Page 26)

Reference (Normalization)

Temperature (tnr)

After saving the temperature unit setting,

the pen will automatically enter the

reference temperature setup.

1. Press ▲ to select 20°C or 25°C.

2. Press SET for less than one second

to conrm the value or press SET for

more than 2 seconds to return to P1.0

without saving.

When meter is in measurement mode,

press " " more than 2 sec to enter

setup mode. Press " "or " " or

" " to select

momentarily again to enter unit setting.

Press " " or " " to select C /F.

Press " " momentarily to confirm the

unit or press " " more than 2 sec to

return to P1.0 without saving.

After confirming the unit, you can

continuously set another temp. related

parameters (except 8371) or press

" " more than 2 seconds to return

to P1.0.

While in P1.0, press " " for more

than 2 seconds to return to measure-

ment mode.

P1.0, then press " "

Short

press

Long

press

Long

press

P1.0: temperature parameter setting: (t)

To change the parameters, you can

press " " more than 2 sec. to enter

setup mode when the meter is in

measurement mode.

P1.1: Change temperature unit (tUt):

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 55 56

Pas de commentaire

Sper-scientific 850037 Large Display Conductivity Pen Manuel d'utilisateur Page 26